Video Tutorial - QCAD Add-On Pattern Drafting

LoriGriffiths · Post by **LoriGriffiths** » Wed Jun 10, 2015 2:25 pm

This video discusses the Fearless Makers QCAD Add-on that was created and shows you how it works.

Using your MD avatar measurements, you can automatically draft basic patterns using QCAD.

https://www.youtube.com/watch?v=RO6SX5MC5jk

Rosemaryr · Post by **Rosemaryr** » Fri Jul 10, 2015 2:49 pm

Very cool!! Even not using QCAD, this had a lot of information I can use in MD. I especially loved that clever 'reference block' of 5 cm to properly scale the patterns to the avatar. I've been eye-balling it for a long time. I'll have to find a way to integrate that in my workflow.

LoriGriffiths · Post by **LoriGriffiths** » Sat Jul 11, 2015 1:51 am

For once I had something for you! I always take so much information from your posts.