Crotch Too Low

If you're using PatternMaker PRO with MD, here's a great place to show off your work or ask questions. All subscribers and non-subscribers are welcome to participate.
Post Reply
JabbaTheNut
Posts: 2
Joined: Thu May 12, 2016 2:50 pm

Crotch Too Low

Post by JabbaTheNut » Thu May 12, 2016 2:59 pm

Hi,

I have created all my avatar measurements using MD (following the PatternMaker PRO instructions) and have input them into PatternMaker PRO. I then selected, downloaded and utilized the male pants pattern #43 (standard pants).

While the overall fit of the finished pant is great, the crotch is very low. Which measurement would I need to change to bring the crotch up?

User avatar
LoriGriffiths
Posts: 353
Joined: Mon Jun 08, 2015 4:39 pm

Re: Crotch Too Low

Post by LoriGriffiths » Tue May 17, 2016 4:32 pm

#43 Pants are very loose fitting and full in the crotch. I would try pants #45 to test your measurements. Also, make sure you put a waistband on them and pull them up to where you measured the waistline. It could be that they are falling down and so the crotch looks low, when it really isn't.

If you still find the crotch is too low, adjust your Crotch Depth measurement. That determines how low it will be.

Hope that helps.

JabbaTheNut
Posts: 2
Joined: Thu May 12, 2016 2:50 pm

Re: Crotch Too Low

Post by JabbaTheNut » Thu May 26, 2016 2:30 am

Awesome, Lori. Thanks :)

Post Reply